SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
9
8
Step 3. Install the Inside Antenna
For areas of 1000 square feet and below allow 30-35 feet of separation between the
booster and the desktop antenna.
Installing Your Hardware
The range of the antenna is dependent on three factors:
1) physical obstructions,
2) power generated by booster
3) reception from outside signal received and
distributed by outside antenna.
• Storage and transportation: Store and place in non-extreme room-temperature
and dry environment
• Attention: This antenna should not be used near open fire or flame
Warning:
Window films that are used to block UV rays also block cellular signals. When using a cellular signal booster with a home comprised of
film-coated windows a booster that comes with an outdoor antenna must be used.
Installing Your Hardware
Step 4. Install the Signal Booster
1. Select a location close to a working AC outlet. Do not expose the signal booster to
excessive heat, direct sunlight, moisture, and airtight enclosures. In areas where there
are higher temperatures, install the booster vertically, so air can move between the metal
channels on the faceplate.
2. Use supplied screws or appropriate screws for surface of mounting location and drill
through screw tabs holes on boosters.
3. Connect the inside antenna cable to the signal booster connector marked
INSIDE
(see
page 14). Hand-tighten the connection.
4. Connect the AC power cord to the signal booster.
5. Connect the plug on the other end of the 110V AC power outlet.
6. Turn the booster’s power switch on.
• The signal booster turns on automatically.
• The
Power
LED lights up to show that the signal booster is ready for use.
• The
Alert
LED flash up to 15 seconds on each band to show the band is activated
Note
:
If the Power LED does not turn ON or the Alert LEDs continue to flash, see Troubleshooting page 11-12.
This booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause
personal injury, and void your warranty.
1. The back of the booster should be pointed in the direction of the nearest cell tower.
Go to www.antennasearch.com for information.
2. Place the table-top antenna in a central location at least 20 feet from the booster.
3. To set the attenuation value please use the chart below for reference. Distance between
antenna and equipment
4.The equipment must be restarted when attenuation adjustments are completed.
Booster
Antenna
Distance between antenna and equipment
10-20 feet
20-35 feet
35-50 feet
15-20 dB
10-15 dB
5-10 dB
Attenuation value
