SUPRENT HC415SA, Быстрый старт, Страница: 3 / 8

Oil
To maintain your clipper in peak condition, the
blades should be oiled every few haircuts.
Do not use hair oil, grease,oil mixed with kerosene
or any solvent. As the solvent will evaporate and
leave the thick oil which may slow down the
motion of the blades.
Blade Adjustable Knob
The knob is conveniently located near your thumb (if you’re right-
handed) so it can easily be adjusted while the clipper is in your hand.
The Knob adds versatility to the clipper by allowing a gradual change
to the closeness of a cut without an attachment comb.
When the Lever is in the uppermost position, the Blades will give the
closest cut leaving the hair very short. Pushing the Lever gradually
downward increases the cutting length
● There’re 3 settings of the length: 0.9/1.2/1.5mm The Lever will also
extend the use of the blades since a different cutting edge is used
in each setting.
● In addition, if extremely heavy hair cutting
has jammed the blades, it will help to
remove hair that has become wedged
between the two blades without removing
the blades.
● While the clipper is running, move the knob
from "close cut" to "long cut" a couple of
times. Doing this each time after use will
help to keep the blades clear of cut hair.
Blade Alignment
Your clippers were carefully examined to ensure that the blades were
oiled and aligned before leaving our factory. Blades must be realigned
if they have been removed for cleaning or replacement. To realign the
blades, simply match the upper and bottom blades teeth up, point for
point. (End of top blade teeth should be approximately 1.2mm back
from the bottom blade. Compare your clipper blades with the sketch.)
1 2
bottom blade
top blade
on/off switch
3mm
9mm
6mm
12mm
comb sclssors
1.2mm
oil brush
blade lever
PARTS NAME PARTS NAME