Supreme Heating HEATSEEKER, Инструкция по установке и эксплуатации

Страница: 9 / 28

07
Heatseeker Solar Pool Heating
Installation & User Manual
CONTROLLER TROUBLESHOOTING
NO POWER TO THE DISPLAY
FAULT REASONS/SOLUTIONS
NO POWER TO THE
DISPLAY
Power point is faulty; test power point with known working appliance. If the
power point is operational, check the controller with another power point and if
there is still no display, then send the controller for repair.
PIPE/ROOF SENSOR FAULTS
The following are error messages caused by pool or roof sensor faults;
FAULT REASONS/SOLUTIONS
SENSOR
DISCONNECTED
Sensor cable unplugged from controller, cable damaged, bad cable join.
SENSOR SHORT
CIRCUIT
Sensor cable damaged, bad cable join.
ISOLATING
SENSOR FAULTS
Swap the sensor locations; simply put the pipe sensor in the roof socket and the
roof sensor in the pipe socket.
If the fault moves from pipe to roof or vice versa, then you can be certain that
there is a sensor fault. If the fault remains the same then the controller will need
repair.
For sensor disconnected or short circuit faults, check for damage to the cable
and repair if required. If no damage can be found, replace the sensor. If the
cable runs underground or inspection is not possible, then cut the sensor from
near the end of the cable and strip back the wires and join them. If the controller
reports a short circuit, then the cable is fine and you may replace the sensor end
if re-routing a new cable is not possible.
If the controller reports a short circuit while the cable is unplugged, then the
controller requires repair.