Connect the drill socket to your drill/driver.
In this guide, you are shown the basic fundamentals
use of your Trailer Valet. Knowing the proper dollying
techniques can help keep you and others around you safe.
Apply your knowledge of your Trailer Valet and the basic
Operating Instructions
8
WARNING
!
Step 3: TESTING THE ASSEMBLY
NOTE: Keeping the trailer jack close to the ground prevents
serious damages from occuring due to unexpected failures.
unable to hold the weight, lower the jack and remove the
device to check air pressure.
1) A ach the drive handle to the low or medium gear of
the drivesha .
WARNING
!
Always ensure the operator and bystanders
are aware of the stability of the load.
1)
If you are using a cordless drill, be sure your
WARNING
!
2) Secu e
Using the Trailer Valet
Step 1: SECURE THE TRAILER VALET
.
uncontrolled trailer movement by locking the Trailer
Step 2: RAISE THE TRAILER VALET
NOTE: Some hitching mechanisms can become stuck to
the ball. Slightly rocking the trailer will loosen the
disconnect any towing safety chains, the brake-turn
Step 4: MOVE THE TOWING VEHICLE
Once the hitch ball of the towing vehicle is detached from
the trailer coupler and the Trailer Valet fully hoists the
trailer, move the towing vehicle away from the trailer.
NOTE: Driving the Trailer Valet with the jack extended will
cause excessive wear on the jack and possibly result in
injury, and/or property damage. Always lower the jack to
its lowest height before moving your trailer with the
Trailer Valet.
WARNING
!
Step 5: CHOOSE YOUR GEAR
greater speed, while the low gear (located at the top
according to your trailer-moving needs.
controlling the trailer.
Mount the Trailer Valet onto the moun ng bracket, drop
Remove the rota on pin (Part Number 23) from the
bo om of the jack and turn the crank (Part Number 3) to
raise the trailer up off the hitch ball, if a ached to a
towing vehicle.
Raise the trailer gradually un l the exis ng jack is above
ground (during first use and un l you ar comfortable with
using the Trailer Valet) and the trailer is completely
supported by the Trailer Valet.
Step 6: ATTACH YOUR PREFERRED DRIVER
drill/driver manufacturer’s recommenda ons. DO NOT
use a drill on the high gear drivesha of the Trailer Valet.
LOW GEAR
HIGH GEAR
r the chuck of your drill around the drill socket
More information https://www.caravansplus.com.au
