t
Set the stow pin to secure the Trailer Valet and set the
Only use the
in the box
Installation
Things you will need to operate your Trailer Valet:
Trailer Valet
Crank Handle
Items sold separately:
Standard Drill/Driver (minimum drive torque
Upon removing the dolly from packaging, it is very
important to thoroughly inspect all parts of the system
before using the device. Any part that is missing or
damaged must be immediately replaced. Contact
Trailer Valet Customer Service at 1-626-400-6299.
1)
2)
WARNING
!
Step 1: CHOOSE A LOCATION ON THE TONGUE WHERE
THE TRAILER VALET CAN FREELY ROTATE FROM ITS
VERTICAL POSITION TO ITS HORIZONTAL STOW
POSITION.
WARNING
!
7
1)
WARNING
The Trailer Valet is only to be installed
on trailer tongues that are rectangular in profile.
Valet as it will rotate, allowing the trailer to drop.
!
Step 2: INSTALL THE MOUNTING BRACKET
The safest way to install the Trailer Valet
is while the trailer is securely mounted to your
vehicle or mounted on an exis ng jack.
WARNING
!
NOTE: It is recommended that you make sure the
Trailer Valet will have the necessary clearance from
the ground to operate and rotate into the stow
2)
NOTE: The trailer should be high enough so that the
Trailer Valet is at least 1 inch off the ground at this
stage of installa on. If the Trailer Valet is not high
enough, adjust trailer height or moun ng bracket
and test again.
3)
S ep 3: SECURE THE TRAILER VALET
WARNING
!
WARNING
!
in
The moun ng bracket has 7 holes to fit a variety of trailer
frames. Have a tongue clearance of at least 13 inches off
the ground before installing the bracket. Set aside 8 inches
of space on the tongue for the moun ng bracket.
WARNING
!
Drill A achment (available at
www.trailervalet.com)
Place the moun ng bracket (Part Number 20) and
clamps (Part Number 21) onto the area of the tongue
you designated in Step 1, and secure onto the tongue
with the 4 bolts, each bolt having one washer, one
spring washer and one nut. Do not completely ghten
the bolts yet.
Evenly and firmly ghten the 4 bolts.
res are damaged due to its failure to hold air. Check re
pressure before using the Trailer Valet for the first me,
since air pressure might have been lost in transit.
Tires must be above 75 psi (pounds per
square inch) prior to use. Do not use the device if the
WARNING
!
WARNING
!
WARNING
!
More information https://www.caravansplus.com.au
