Supero x7dwa-N, Руководство пользователя

Страница: 118 / 132

D-10
X7DWA-N User's Manual
Notes:
1. Before adding a new drive to an array, be sure to back up any data stored on
the new drive; otherwise, all data will be lost.
2. If you stop the Build or Clear process on a RAID 1, you can restart it by press-
ing <Ctrl> and <R>.
3. If you've used the Quick Init option to create a RAID1, it may return some data
mis-matched when you run a consistency check at a later time. This is normal.
4. The Adaptec Host RAID allows you to use drives of different sizes in a RAID
setting. However, you can only select a smaller drive as the source or fi rst drive
during a building operation.
5. When migrating from a single volume to RAID 0, migrating from a larger drive
to a smaller drive is allowed. However, the destination drive must be at least half
the capacity of the source drive.
6. It is not recommended that you migrate or build an array on Windows dynamic
disks (volumes) because it will result in data loss.
*Warning : Do not interrupt the process when you create a RAID 0 using the
Migrate option. If you do, you will not be able to restart the system, or to recover
the data that was on the source drive.
5. When you are fi nished, press <Done> (as the screen shown below).