Supero SuperServer 6028R-TR, Руководство пользователя

Страница: 67 / 126

Chapter 5: Advanced Serverboard Setup
5-21
CMOS Clear
JBT1 is used to clear CMOS (which will also clear any passwords). Instead of pins,
this jumper consists of contact pads to prevent accidentally clearing the contents
of CMOS.
To clear CMOS,
1. First power down the system and unplug the power cord(s).
2. With the power disconnected, short the CMOS pads with a metal object such
as a small screwdriver.
3. Remove the screwdriver (or shorting device).
4. Reconnect the power cord(s) and power on the system.
Note: Do not use the PW_ON connector to clear CMOS.
LAN1/LAN2 Enable/Disable
Use JPL1 to enable/disable the LAN
ports 1/2. See the table on the right
for jumper settings. The default setting
is Enabled.
LAN1/2 Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog Enable/Disable
Jumper JWD controls the Watch Dog
function. Watch Dog is a system moni-
tor that can reboot the system when a
software application hangs. Close pins
1-2 to to reset the system if an applica-
tion hangs. Close pins 2-3 to generate
a non-maskable interrupt signal for the
application that hangs. See the table
on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled