Supero SuperServer 6027R-3RF4+, Руководство пользователя

Страница: 59 / 122

Chapter 5: Advanced Serverboard Setup
5-13
5-7 Adding PCI Add-On Cards
The 6027R-3RF4+ can accommodate up to six full-length, low-profi le PCI add-on
cards (four x16 cards, one x8 card and one x4 card in a x8 slot).
Installing an Add-on Card
1. Begin by removing the shield for the PCI slot you wish to populate.
2. Fully seat the card into the slot, pushing down with your thumbs evenly on
both sides of the card.
3. Finish by using a screw to secure the top of the card shield to the chassis.
The PCI slot shields protect the serverboard and its components from EMI
and aid in proper ventilation, so make sure there is always a shield covering
each unused slot.
Populating LRDIMM (ECC) Memory Modules
Intel E5-2600 Series Processor LRDIMM Memory Support-Table
Ranks Per
DIMM & Data
Width
(See the Note
Below)
Memory Capacity
Per DIMM
Speed (MT/s) and Voltage Validated by Slot per
Channel (SPC) and DIMM Per Channel (DPC)
3 Slots Per Channel
1DPC and 2DPC 3DPC
1.35V 1.5V 1.35V 1.5V
QRx4 (DDP) 16GB 32GB 1066 1066,
1333
1066 1066
QRx8 (P) 8GB 16GB 1066 1066,
1333
1066 1066
Note: For detailed information on memory support and updates, please refer to the SMC Recom-
mended Memory List posted on our website at http://www.supermicro.com/support/resources/
mem.cfm.
Other Important Notes and Restrictions
•
For the memory modules to work properly, please install DIMM modules of the
same type, same speed and same operating frequency on the motherboard.
Mixing of RDIMMs, UDIMMs or LRDIMMs is not allowed. Do not install both
ECC and Non-ECC memory modules on the same motherboard.
•
Using DDR3 DIMMs with different operating frequencies is not allowed. All chan-
nels in a system will run at the lowest common frequency.