Supero SUPERSERVER 6017TR-TF, Руководство пользователя

Страница: 62 / 140

5-10
SUPERSERVER 6017TR-TQF/TFF/TF User's Manual
5-5 Installing Memory
Caution: exercise extreme care when installing or removing DIMM modules to prevent
any possible damage.
Installing Memory
1. Insert the desired number of DIMMs into the memory slots, starting with P1-
DIMM #A1. Push the release tabs outwards on both ends of the DIMM slot to
unlock it.
2. Align the key of the DIMM module with the receptive point on the memory
slot.
3. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
4. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
5. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Note: 512 MB, 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size memory modules
are supported. It is highly recommended that you remove the power cord from the
system before installing or changing memory modules. Please refer to our web site
for memory that has been tested on the X9DRT-IBQF/IBFF/F serverboard.
Removing Memory Modules
Press both notches on the ends of the DIMM module to unlock it. Once the DIMM
module is loosened, remove it from the memory slot.
Memory Support
The X9DRT-IBQF/IBFF/F serverboard supports DDR3-1600/1333/1066/800 MHz
speed registered ECC/Unbuffered ECC/non-ECC SDRAM. Populating two slots at
a time with memory modules of the same size and type will result in interleaved
(128-bit) memory, which is faster than non-interleaved (64-bit) memory.”
Note: Check the Supermicro website ( www.supermicro.com ) for the latest memory
support information.
Maximum Memory
The X9DRT-IBQF/IBFF/F serverboard supports up to 256 GB of ECC 240-pin
Registered (RDIMM)/Load Reduced (LRDIMM) ECC memory or up to 64 GB of
Unbuffered (UDIMM) non-ECC memory in eight (8) DIMM slots.