Supero SUPERSERVER 6014P-T, Руководство пользователя

Страница: 68 / 124

6-10
S
UPER
S
ERVER 6014P-T/6014P-TR User's Manual
Reconfi guring the Power Supply
Although the standard confi guration for the 6014P-T and 6014P-TR is with single
and dual (redundant) power supplies respectively, you can reconfi gure the 6014P-
T to hold two power supply modules or (not recommended) the 6014P-TR to hold
a single power supply module. The alternate backpanel section you will need for
either operation has been included with the system.
Note: in the following instructions, "right" and "left" refers to the side noted when
viewed from the rear of the system.
Reconfi guring the 6014P-T (see Figure 6-6)
1. You will fi rst need to power down the system and remove the power cord. To gain
access to the inside of the system, pull the server out from the rack and remove
the top chassis cover by following the instructions on page 2-8.
2. Remove any expansion card that may be installed in the right-side riser card.
3. Remove the three screws that secure the riser card bracket, which runs from
the primary ATX power connector to the rear of the chassis. After the screws are
removed, lift the riser card bracket out from the chassis.
4. At the rear of the power distribution board (where the second power supply
is inserted), there is a vertical shield that protects the second power supply slot.
Remove this shield by grasping and forcibly pulling it off the cover that protects the
power distribution board.
Figure 6-5. Removing/Replacing the Power Supply