Supero SUPERSERVER 6014P-8, Руководство пользователя

Страница: 54 / 126

5-20
S
UPER
S
ERVER 6014P-8/6014P-8R/6014P-82R/6014P-82 User's Manual
GLAN Enable/Disable
Change the setting of jumper JPL1
to enable or disable the LAN ports
( G L A N 1 / 2 o r J L A N 1 / 2 ) o n t h e
serverboard. See the table on the
right for jumper settings. The de-
fault setting is enabled
Jumper
Position
Pins 1-2
Pins 2-3
Definition
Enabled
Disabled
GLAN
Enable/Disable
Jumper Settings
(JPL1)
5-9 Jumper Settings
Explanation of
Jumpers
T o m o d i f y t h e o p e r a t i o n o f t h e
serverboard, jumpers can be used
t o c h o o s e b e t w e e n o p t i o n a l
settings. Jumpers create shorts
between two pins to change the
function of the connector. Pin 1 is
identified with a square solder pad
on the printed circuit board. See
the serverboard layout pages for
jumper locations.
N o t e : O n t w o p i n j u m p e r s ,
"Closed" means the jumper is on
and "Open" means the jumper is
off the pins.
Connector
Pins
Jumper
Cap
Setting
Pin 1-2 short
3 2 1
3 2 1
CMOS Clear
JBT1 is used to clear CMOS (which will also clear any passwords). In-
stead of pins, this jumper consists of contact pads to prevent accidentally
clearing the contents of CMOS.
To clear CMOS,
1) First power down the system and unplug the power cord(s)
2) With the power disconnected, short the CMOS pads with a metal object
such as a small screwdriver
3) Remove the screwdriver (or shorting device)
4) Reconnect the power cord(s) and power on the system.
Note: Do not use the PW_ON connector to clear CMOS.