Supero SuperServer 5016I-MT, Руководство пользователя

Страница: 24 / 102

2-8
S
UPER
S
ERVER 5016I-MT/5016I-MTF User's Manual
2-5 Checking the Motherboard Setup
After you install the 5016I-MT/5016I-MTF in the rack, you will need to open the
unit to make sure the motherboard is properly installed and all the connections
have been made.
Accessing the Inside of the System
Grasp the two handles on either side and pull the unit straight out until it 1.
locks (you will hear a "click").
Depress the two buttons on the top of the chassis to release the top cover. 2.
There is a large rectangular recess in the middle front of the top cover to help
you push the cover away from you until it stops.
Lift the top cover from the chassis to gain full access to the inside of the 3.
server. See Figure 2-4.
Checking the Components
You may have the processor already installed into the system board. The 1.
processor should have its own heatsink attached. See Chapter 5 for instruc-
tions on processor installation.
Your server system may have come with system memory already installed. 2.
Make sure all DIMMs are fully seated in their slots. For details on adding
system memory, refer to Chapter 5.
If desired, you can install an add-on card to the system. See Chapter 5 for 3.
details on installing a PCI add-on card.
Make sure all power and data cables are properly connected and not blocking 4.
the airfl ow. See Chapter 5 for details on cable connections.