Chapter 4: AMI BIOS
4-15
SATA RAID Option ROM/UEFI Driver
This item enables either the on board SATA option ROM or the EFI driver. The
options are
Enabled
or Disabled.
If AHCI is selected in SATA Mode Selection above, the following items are displayed:
Serial ATA Port 0~ Port 5
This item displays the information detected on the SATA device installed on a
particular SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Port 0 ~ Port 5 Hot Plug
This feature designates the port specified as hot pluggable. Set this item to
Enabled to enable hot-plugging support. The options are Hard Disk Drive and
Solid State Drive.
Port 0 ~ Port 5 SATA Device Type
This feature configures the selected SATA port to support either a solid state
drive or hard disk drive. The options are
Hard Disk Drive
and Solid Sate Drive.
Port 0 ~ Port 5 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization sequence to the device. The options are Enabled and
Disabled
.
SATA Gen3 Port 0 ~ Port 5 Length Value
Use this item to set a value for Gen3 length test. The values that can be selected
ranges from
[00 0000b]
through [00 1111b].
SATA Gen2 Port 0 ~ Port 5 Length Value
Use this item to set a value for Gen3 length test. The values that can be selected
ranges from
[00 0000b]
through [00 1111b].
If IDE is selected in SATA Mode Selection above, the following items are displayed:
Serial ATA Port 0 ~ Port 5
This item displays the information detected on the installed SATA drives on the
particular SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
