Chapter 2: Installation
2-5
2-4
Installing DDR Memory
CAUTION
Exercise extreme care when installing or removing memory
modules to prevent any possible damage.
Memory Module Installation (See Figure 2-2)
1.
Insert each DDR memory module vertically into its slot. Pay attention to
the notch along the bottom of the module to prevent inserting the mod-
ule incorrectly. (See support information below.)
2.
Gently press down on the memory module until it snaps into place.
3.
Two 184-pin memory sockets support up to 2 GB unbuffered non-ECC
DDR type SDRAM (see support information below).
Support
The P4SGA/P4SGL supports both double-sided and single-sided non-
registered, unbuffered PC2100 (DDR-266) or PC1600 (DDR-200)
SDRAM. The P4SGR/P4SGE/P4SGA+ supports both double-sided and
single-sided non-registered, unbuffered PC2700 (DDR-333) or PC2100
(DDR-266) SDRAM. Always populate DIMM1 first.
To Install:
Insert module
vertically and
press down
until it snaps
into place.
Pay attention
to the notch.
Figure 2-2. Side and Top Views of DDR Module Installation into Slot
To Remove:
Use your thumbs
gently to push
each release tab
outward to
release the DIMM
from the slot.
