Supero H8QM3-2+, Руководство пользователя

Страница: 74 / 76

B-6
H8QM3-2+/H8QMi-2+ User's Manual
Checkpoint Code Description
86h The password was checked. Performing any required programming before
WINBIOS Setup next.
87h The programming before WINBIOS Setup has completed. Uncompressing
the WINBIOS Setup code and executing the AMIBIOS Setup or WINBIOS
Setup utility next.
88h Returned from WINBIOS Setup and cleared the screen. Performing any
necessary programming after WINBIOS Setup next.
89h The programming after WINBIOS Setup has completed. Displaying the
power on screen message next.
8Ch Programming the WINBIOS Setup options next.
8Dh The WINBIOS Setup options are programmed. Resetting the hard disk
controller next.
8Fh The hard disk controller has been reset. Configuring the floppy drive
controller next.
91h The floppy drive controller has been configured. Configuring the hard disk
drive controller next.
95h Initializing the bus option ROMs from C800 next. See the last page of this
chapter for additional information.
96h Initializing before passing control to the adaptor ROM at C800.
97h Initialization before the C800 adaptor ROM gains control has completed.
The adaptor ROM check is next.
98h The adaptor ROM had control and has now returned control to BIOS
POST. Performing any required processing after the option ROM returned
control.
99h Any initialization required after the option ROM test has completed. Config-
uring the timer data area and printer base address next.
9Ah Set the timer and printer base addresses. Setting the RS-232 base ad-
dress next.
9Bh Returned after setting the RS-232 base address. Performing any required
initialization before the Coprocessor test next.
9Ch Required initialization before the Coprocessor test is over. Initializing the
Coprocessor next.
9Dh Coprocessor initialized. Performing any required initialization after the
Coprocessor test next.
9Eh Initialization after the Coprocessor test is complete. Checking the extended
keyboard, keyboard ID, and Num Lock key next. Issuing the keyboard ID
command next.
A2h Displaying any soft errors next.
A3h The soft error display has completed. Setting the keyboard typematic
rate next.
A4h The keyboard typematic rate is set. Programming the memory wait states
next.
A5h Memory wait state programming is over. Clearing the screen and enabling
parity and the NMI next.
A7h NMI and parity enabled. Performing any initialization required before pass-
ing control to the adaptor ROM at E000 next.
A8h Initialization before passing control to the adaptor ROM at E000h com-
pleted. Passing control to the adaptor ROM at E000h next.