Supero H8QG6-F, Руководство пользователя

Страница: 27 / 84

Chapter 2: Installation
2-5
Gently press down on the memory module until it snaps into place. 3.
With four CPUs installed, repeat step 2 to populate the CPU2 DIMM slots. 4.
Always install four DIMMs to both CPU DIMM slots for more effi cient
operation.
Note: 1 GB, 2 GB, 4 GB, 8 GB and 16 GB memory modules are supported. It
is highly recommended that you remove the power cord from the system before
installing or changing memory modules. Please refer to our web site for memory
that has been tested on the H8QG6/i-F serverboard.
Memory Support
The H8QG6/i-F serverboard supports single/dual/tri/quad-channel, DDR3-
1333/1066/800 registered ECC/Unbuffered ECC/non-ECC SDRAM. Only
interleaved memory is supported, so you must populate four DIMM slots at a time
(see procedure above).
Populating four adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
The H8QG6/i-F serverboard supports up to 512 GB of DDR3-1333/1066/800
registered ECC or 128GB of DDR3 Unbuffered ECC/non-ECC SDRAM.
Figure 5-3. Installing DIMM into Slot
To I n s t a l l : I n s e r t
module vertically and
press down until it
snaps into place. Pay
attention to the align-
ment notch at the
bottom.
To R e m o v e : U s e
your thumbs to gen-
tly push the release
tabs near both ends
of the module. This
should release it from
the slot.
Top View of DDR3 Slot
Release Tab Release Tab
Note: Notch should align with
the receptive key point on
the slot.
Notch Notch
Front View