Supero H8DGT-H, Руководство пользователя

Страница: 29 / 76

Chapter 2: Installation
2-5
Note: The H8DGT-HF/HIBQF serverboards support sixteen (16) memory modules
of 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size. It is highly recommended that
you remove the power cord from the system before installing or changing memory
modules. Please refer to our web site for memory that has been tested on the
H8DGT-HF/HIBQF serverboard.
Support
The H8DGT-HF/HIBQF serverboard supports single/dual/tri/quad-channel,
DDR3-1600/1333/1066 MHz SDRAM.
Populating four adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
The H8DGT-HF/HIBQF serverboard can support a maximum memory size of up
to 128 GB of ECC/Non-ECC UDIMM or up to 512 GB of ECC RDIMM/LRDIMM
SDRAM.
Figure 2-1. DIMM Installation
To Install: Insert module
vertically and press down
until it snaps into place.
P a y a t t e n t i o n t o t h e
alignment notch at the
bottom.
To Remove: Use your
thumbs to gently push
the release tabs near both
ends of the module. This
should release it from
the slot. Top View of DDR3 Slot
Release Tab Release Tab
Note: Notch should
align with the receptive
key point on the slot.
Notch Notch
Front View