Supero AS 4040C-TR, Руководство пользователя

Страница: 70 / 104

6-8
AS4040C-TR/4040C-8R User's Manual
Installing Components in the 5.25" Drive Bays
1. Drive bay confi guration
The 4040C-TR/4040C-8R has three 5.25" drive bays. Components such as an
extra fl oppy drive, IDE hard drives or DVD/CD-ROM drives can be installed into
these 5.25" drive bays.
2. Mounting components in the drive bays
First power down the system and then remove the top/left chassis cover to access
the drive components. With the cover off, remove the two or four screws that
secure the drive carrier to the chassis (one side only) then push the entire empty
drive carrier out from the back.
Adding a DVD/CD-ROM drive: remove the guide plates (one on each side) from
the empty drive carrier and screw them into both sides of the DVD/CD-ROM drive
using the holes provided. Then slide the DVD/CD-ROM into the bay and secure
it to the chassis with the drive carrier screws you fi rst removed. Attach the power
and data cables to the drive. Replace the top/left chassis cover before restoring
power to the system.
Adding an IDE or fl oppy drive: to add one of these drives, install it into one of the
removed empty drive carriers with the printed circuit board side toward the carrier
so that the drive's mounting holes align with those in the carrier. Secure the drive
to the carrier with four screws then slide the assembly into the bay and secure it to
the chassis with the drive carrier screws you fi rst removed. Attach the power and
data cables to the drive. Replace the top/left chassis cover before restoring power
to the system.
Note: A red wire typically designates the location of pin 1. You should keep the
drive carriers inserted in any unused drive bays to reduce EMI and noise and to
facilitate the airfl ow inside the chassis.
Figure 6-7. Adding a Component Without a Drive Carrier