Supero AOC-STG-i2T, Руководство пользователя

Страница: 15 / 27

Chapter 2: Hardware Components
2-5
2-4 Jumpers and Indicators for
Rev. 1.01
Explanation of Jumpers
To modify the operation of the add-on card, a
jumper can be used to choose between optional
settings. A jumper creates shorts between two
pins to change the function of the connector. Pin
1 is identified with a square solder pad on the
printed circuit board. See the add-on card layout
on Page 2-1 for the jumper location.
Note: On two-pin jumpers, "Closed"
means the jumper is on and "Open"
means the jumper is off the pins.
Connector
Pins
Jumper
Cap
Setting
Pin 1-2 short
3 2 1
3.3V Standby PWR Enable
Jumper Settings
Jumper setting Definition
1-2 Enabled
(See the note below)
2-3 Disabled (default)
3.3V Standby Power Enable
The 3.3V Standby Power Enable jumper is
located at J2 on the add-on card. Refer to the
layout on Page 2-1 for the location of the jump-
er. Close Pins 1 & 2 to enable 3.3V Standby
Power for Wake-on-LAN support. The default
setting is
Disabled .
3 2 1
Note : If this jumper is set to "Enabled", LAN chip overheat may occur.
Be sure to provide adequate system cooling when the jumper is enabled.