Supero 4021A-T2, Руководство пользователя

Страница: 37 / 104

Chapter 5: Advanced Serverboard Setup
5-5
5-4 Connecting Cables
Now that the processors are installed, the next step is to connect the cables to the
serverboard. These include the data (ribbon) cables for the peripherals and control
panel and the power cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices have been
carefully routed in preconfi gured systems to prevent them from blocking the fl ow
of cooling air that moves through the system from front to back. If you need to
disconnect any of these cables, you should take care to reroute them as they were
originally after reconnecting them (make sure the red wires connect to the pin 1
locations). If you are confi guring the system, keep the airfl ow in mind when routing
the cables. The following data cables (with their serverboard connector locations
noted) should be connected. See the serverboard layout diagram in this chapter
for connector locations.
Floppy Drive cable (JFDD1)
Serial ATA cables (SATA0 ~ SATA5)
Control Panel cable (JF1, see next page)
USB cable for front access (USB4/5)
Connecting Power Cables
The H8DAE-2 has a 24-pin primary ATX power supply connector designated
"JPW1" for connection to the ATX power supply. Connect the appropriate con-
nector from the power supply to the "ATX Power" connector to supply power to
the serverboard. See the Connector Defi nitions section in this chapter for power
connector pin defi nitions.
In addition, your power supply must be connected to the 8-pin Processor Power
connection at JPW2. For systems with high load confi gurations, a third power con-
nector at PW3 should also be connected to your power supply.
•
•
•
•