Supermicro X6QT8, Руководство пользователя

Страница: 28 / 110

2-6
X6QT8/X6QTE+ User's Manual
2-3 Installing DIMMs
CAUTION
Exercise extreme care when installing or removing
DIMM modules to prevent any possible damage. Also note that
the memory is interleaved to improve performance.
DIMM Installation (See Figure 2-2)
1. Insert the desired number of DIMMs into the memory slots, starting with the fi rst
DIMM of the fi rst bank. Each UXMB chip is independent from each other,
so memory modules can be installed on the fi rst bank of a UXMB Controller.
For best memory performance, 8 memory modules minimal are required (-2
modules for each UXMB chip. See the Memory Table below.)
2. To optimize memory performance, install DIMM modules in the following slots fi rst:
DIMMs A1& B1, DIMMs A3 & B3, DIMMs A5 & B5, DIMMs A7 & B7.
3. Insert each DIMM module vertically into its slot. Pay attention to the notch along
the bottom of the module to prevent inserting the DIMM module incorrectly.
4. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules.
Memory Support
The X6QT8/X6QTE+ supports up to 64 GB of Reg. ECC DDR2 533/400 (PC3200)
memory. (Note: Due to OS limitations, some operating systems may not support
more than 4GB of memory.)
Figure 2-2. Installing and Removing DIMMs
To Install: Insert mod-
ule vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
2
DIMM Memory
Bank 1 Bank 2
UXMB1
A1 B1 A2 B2
UXMB2
A3 B3 A4 B4
UXMB3
A5 B5 A6 B6
UXMB4
A7 B7 A8 B8
!