SuperServer 2029U-TN24R4T User's Manual
170
Notes for Installing in the Middle Position (2)
•
Break off the necessary portions of the shroud to allow for cables. In particular, remove
the top row of the shroud "ramp" as labeled below.
•
Position the shroud as shown. The right side wall of the shroud should not cover the right-
most DIMM (P1-DIMMC1). The hole near the center of the shroud fits over the standoff in
the center of the chassis. The left wall of the shroud fits next to CPU2.
•
Routing the GPU power cables:
You will likely have to route the cables to the motherboard
connector before fully seating the riser bracket. Guide the cables to the right between the
GPU and the shroud and down to the GPU_PWR1 connector on the motherboard.
Installing the Air Shroud for the
Middle GPU (MCP-310-21904-0B)
Slot for
Shroud Tabs
Break off top row
of shroud "ramp."
Break off tabs if
necessary.
Figure F-8. Installing a GPU in the Middle of the Chassis
Route GPU power
cable by this edge
of the shroud.
