Chapter 3: Advanced Chassis Setup
3-1
Chapter 3
Advanced Chassis Setup
This chapter covers the steps required to install or replace components in the
E100-015E chassis. The only tool required is a Phillips screwdriver.
Review the warnings and precautions listed in the manual before setting up or
servicing this chassis. These include information in Chapter 4 and in the setup
instructions.
3-1 Removing Power
Before performing most setup or maintenance tasks, use the following procedure
to ensure that power has been disconnected from the system.
1. Use the host system to power down the system.
2. After the system has completely shut down, remove the power adapter cord
from the front of the chassis.
3. Remove the power adapter from the power strip or wall outlet.
Figure 3-1. Front View
Figure 3-2. Rear View
