Supermicro SUPERSERVER 8044T-8R, Руководство пользователя

Страница: 73 / 102

Chapter 7: BIOS
7-5
C1 Confi guration Mode
(Available when supported by the CPU.)
Select Standard to enable the C1 Halt State to partially turn off the CPU internal
clocks to conserve energy and prevent system overheating when the OS is idle.
Select Enhanced to enable the Enhanced C1 Halt State to lower the CPU clock
frequency and the supply voltage before turning off the clocks.
IDE Confi guration Sub-Menu
When this sub-menu is selected, the AMI BIOS automatically displays the follow-
ing items:
IDE Confi guration
This feature allows the user to confi gure the IDE mode. The options are Disabled,
P-ATA (Parallel ATA) only, S-ATA (Serial ATA) only and
P-ATA & S-ATA .
Combined Mode Operation
This feature allows the user to select the IDE Combined Mode. The options are
P-ATA 1st Channel and S-ATA 1st Channel.
S-ATA Ports Defi nition
This feature allows the user to confi gure the Serial ATA Ports. The options are
P0-Master/P1-Slave and P0-Slave/P1-Master
.
Primary IDE Channel Master/Slave, Secondary IDE Channel Master/
Slave
These settings allow the user to set the parameters of Primary IDE Channel Master/
Slave and Secondary IDE Channel Master/Slave slots. Hit <Enter> to activate
the following sub-menu screen for detailed options of these items. Set the correct
confi gurations accordingly. The items included in the sub-menu are:
Type
Select the type of device connected to the system. The options are Not Installed,
Auto , CDROM and ARMD.
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk drive.
In the LBA mode, the maximum drive capacity is 137 GB. For drive capacities
over 137 GB, your system must be equipped with a 48-bit LBA mode addressing.
If not, contact your manufacturer or install an ATA/133 IDE controller card that
supports 48-bit LBA mode. The options are Disabled and Auto .
Block (Multi-Sector Transfer)
Block Mode boosts the IDE drive performance by increasing the amount of data
transferred. Only 512 bytes of data can be transferred per interrupt if Block Mode
is not used. Block Mode allows transfers of up to 64 KB per interrupt. Select
"Disabled" to allow the data to be transferred from and to the device one sector
at a time. Select " Auto " to allows the data transfer from and to the device occur
multiple sectors at a time if the device supports it.