Supermicro SUPERSERVER 6015V-T, Руководство пользователя

Страница: 24 / 122

2-8
S
UPER
S
ERVER 6015V-T/6015V-TLP User's Manual
2-5 Checking the Serverboard Setup
After you install the 6015V-T/6015V-TLP in the rack, you will need to open the unit
to make sure the serverboard is properly installed and all the connections have
been made.
1. Accessing the inside of the system (Figure 2-5)
First, grasp the two handles on either side and pull the unit straight out until it locks
(you will hear a "click"). Next, depress the two buttons on the top of the chassis to
release the top cover. There is a large rectangular recess in the middle front of the
top cover to help you push the cover away from you until it stops. You can then lift
the top cover from the chassis to gain full access to the inside of the server.
2. Check the CPU (processor)
You may have one or two processors already installed into the system board. Each
processor should have its own heatsink attached. See Chapter 5 for instructions
on processor and heatsink installation.
3. Check the system memory
Your 6015V-T/6015V-TLP server system may have come with system memory
already installed. Make sure all DIMMs are fully seated in their slots. For details
on adding system memory, refer to Chapter 5.
4. Installing add-on cards
If desired, you can install an add-on card to the system. See Chapter 5 for details
on installing a PCI add-on card.
5. Check all cable connections and airfl ow
Make sure all power and data cables are properly connected and not blocking the
airfl ow. See Chapter 5 for details on cable connections. Also, check the air seals
for damage. The air seals are located under the blower fan and beneath the frame
cross section that separates the drive bay area from the serverboard area of the
chassis.