Supermicro SUPERSERVER 6015V-T, Руководство пользователя

Страница: 20 / 122

2-4
S
UPER
S
ERVER 6015V-T/6015V-TLP User's Manual
Figure 2-1. Identifying the Sections of the Rack Rails
A
B
2-4 Installing the System into a Rack
This section provides information on installing the SuperServer 6015V-T/6015V-
TLP into a rack unit. If the system has already been mounted into a rack, you
can skip ahead to Sections 2-5 and 2-6. There are a variety of rack units on the
market, which may mean the assembly procedure will differ slightly. The following
is a guideline for installing the unit into a rack with the rack rails provided with the
system. You should also refer to the installation instructions that came with the
rack unit you are using.
Identifying the Sections of the Rack Rails
You should have received two rack rail assemblies with the SuperServer 6015V-
T/6015V-TLP. Each of these assemblies consist of two sections: an inner fi xed
chassis rail that secures to the unit (A) and an outer fi xed rack rail (B) that secures
to the rail brackets. A sliding rail guide sandwiched between the two should remain
attached to the fi xed rack rail (see Figure 2-1). The A and B rails must be detached
from each other to install.
To remove the fi xed chassis rail (A), pull it out as far as possible - you should hear
a "click" sound as a locking tab emerges from inside the rail assembly and locks
the inner rail. Then depress the locking tab to pull the inner rail completely out.
Do this for both the left and right side rack rail assemblies.
Pull out the inner
rail(to be attached
on the chassis)
Outer rail (to be
installed in the
rack)