Supermicro FatTwin F627G2-F73+, Руководство пользователя

Страница: 19 / 146

1-9
Chapter 1: Introduction
1-6 Fat Twin: System Notes
As a FatTwin confi guration, the FatTwin F627G2-FT+/FTPT+/F73+/F73PT+ is a
unique server system. With four system boards incorporated into a single chassis
acting as four separate nodes, there are several points you should keep in mind.
Nodes
Each of the four serverboards act as a separate node in the system. As independant
nodes, each may be powered off and on without affecting the others. In addition,
each node is a hot-swappable unit that may be removed from the rear of the chassis.
The nodes are connected to the server backplane by means of an adapter card.
Note: A guide pin is located between the upper and lower nodes on the inner chassis
wall. This guide pin also acts as a “stop” when a node is fully installed. If too much
force is used when inserting a node this pin may break off. Take care to slowly slide
a node in until you hear the “click” of the locking tab seating itself.
System Power
Four 1620 Watt power supplies are used to provide the power for all serverboards.
Each serverboard however, can be shut down independently of the other with the
power button on its own control panel.
SAS/SATA Backplane/Drives
As a system, the FatTwin F627G2-FT+/FTPT+/F73+/F73PT+ supports the use of
twenty-four (24) 2.5" Hot-swap SAS/SATA drives. Each of the four backplanes in
the system works to apply system-based control for power and fan speed functions,
yet at the same time logically connects a set of six SAS/SATA drives to each
backplane/serverboard. Consequently, RAID setup is limited to a six-drive scheme
(RAID cannot be spread across all drives). See Chapter 6 for the logical hard drive
and node confi guration.