Chapter 2: Server Installation
19
Warning:
Stability hazard. The rack stabilizing mechanism must be in place, or the
rack must be bolted to the floor before you slide the unit out for servicing. Failure to
stabilize the rack can cause the rack to tip over.
2.4 Installing the Chassis into a Rack
Once rails are attached to the chassis and the rack, you can install the server.
1. Align the rear of the chassis rails with the rack rails and then push evenly on both sides
of the chassis until it clicks into the fully extended position.
2. Depress the locking tabs on both sides of the chassis and push the it fully into the rack.
The locking tabs should "click".
3. Thumb screws may be used to secure the front of the chassis to the rack.
Figure 2-3. Installing the Server into the Rack
Notes:
Figure is for illustrative purposes only. Always install servers to the bottom of a rack
first.
