Supermicro AS-1010P-8, Руководство пользователя

Страница: 42 / 102

5-8
AS1010P-8(R)/1010P-T(R) User's Manual
Figure 5-4. Side and Top Views of DDR Installation
To Install:
Insert module vertically
and press down until it
snaps into place. The
release tabs should
close - if they do not
you should close them
yourself.
To Remove:
Use your thumbs to
gently push each re-
lease tab outward to
release the DIMM from
the slot.
Note the notch in the slot and on the bottom of the DIMM.
These prevent the DIMM from being installed incorrectly.
Support
The H8SSP-8 / H8SSP-i supports single or dual-channel, registered ECC
DDR400/333/266 SDRAM.
Both interleaved and non-interleaved memory are supported, so you may populate
any number of DIMM slots (see note on previous page).
Populating two adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum memory : 16 GB for DDR333/266 and 8 GB for DDR400.