Superlift RDO-1BP, Руководство пользователя

Страница: 2 / 16

- 2 -
RDO1BP B
IMPORTANT SAFETY RECOMMENDATIONS
FAILURE TO COMPLY WITH THE FOLLOWING SAFETY RECOMMENDATIONS MAY
RESULT IN SERIOUS PERSONAL INJURY, DEATH AND/OR PROPERTY DAMAGE .
1.
READ AND FOLLOW ALL SAFETY AND INSTALLATION INSTRUCTIONS
CAREFULLY.
2. The installation of your new Automatic Garage Door Opener (herein after referred to as
“AGDO”) must be carried out by a technically qualified or licensed person. Attempting to
install your new AGDO without suitable technical qualification may result in severe
personal injury, death and/or property damage.
3. Only install the AGDO on a properly balanced and aligned, well functioning Garage Door. An
improperly balanced or malfunctioning Garage Door could cause serious injury. Have a qualified
person check and if required, make repairs to your Garage Door
before installing the AGDO. As a
general rule, your Garage Door is deemed to be well balanced and aligned if it;
a. requires an equivalent amount of applied force to manually open or close and,
b. requires no more than 150N of applied force to either manually open or close and,
c. does not rise or fall more than 100mm when stopped at any position between fully open or
fully closed positions and,
d. does not rub on or make contact with any supporting or surrounding structures.
4. Repairs to Garage Doors must only be carried out by technically qualified persons. Attempting to
repair the Garage Door without suitable technical qualification may result in severe personal
injury, death and/or property damage.
5. Remove or render inoperative all existing locks and ropes prior to installation of the AGDO.
6. The counter balance springs on sectional type doors must be properly lubricated between all of
the coils with heavy automotive bearing grease. Failure to adequately lubricate the springs may
result in one or more of the following symptoms;
a. The springs will become rusty over time resulting in extra operating friction between the
coils which may cause the AGDO to malfunction.
b. Seasonal temperature changes may cause the Garage Door springs to expand and/or contract.
The resultant increase and/or decrease in operating friction may cause the AGDO to
malfunction. Properly lubricating the springs will help to minimize the effect of seasonal
temperature changes in operating friction of your Garage Door.
7. If possible, install the AGDO at least 2 meters or more above the ground. Adjust the Manual
Release Chord so that it hangs approximately 1.8 meters from the ground.
8. Do not connect the AGDO to the power source until this manual instructs you to do so.
9. The AGDO must be connected to a properly earthed general purpose 240V outlet which has
been installed by a qualified electrical contractor.
10. Locate the wall control panel/push button;
a. within site of the Garage Door and,
b.
at a minimum height of 1.5 meters above the ground so that it remains out of the reach of
small children and,
c. away from all moving parts of the door.
11. Install the Entrapment Warning Label in a prominent position next to the wall control button.
12. The Manual Release Instruction Tag must remain attached to the Manual Release Chord.
13. After installing and correctly adjusting the AGDO, the Garage Door must stop and reverse
direction when it comes into contact with a 35mm high solid object placed on the floor under the
Garage Door.
14. The correct function of the Safety Obstruction Reversing System should be checked on a monthly
basis. Make sure that the Garage Door reverses when it makes contact with an obstruction.
15. Never use the AGDO unless the Garage Door is in full view and free from objects such as cars,
children and/or adults.