Superior spx 960, Инструкция по эксплуатации и техническому обслуживанию, Страница: 92 / 112

Istruction Manual for Operation and Maintenance
SPX-960
:
5.7.2 FUSES
The fuses are installed on the control panel (32 in Fig. 66):
they protect the entire electrical system. Refer to the electrical
diagram supplied separately for the different circuits protected
by the fuses.
To replace blown fuses, extract the fuse that has blown off and
replace it with a new one.
When a fuse blows off, replace it immediately. If the same
fuse blows again, ask competent and authorized personnel
to check it.
5.7.3 LIGHTS
The machine is supplied with lights (1, 2 & 3 in Fig. 67) on
all three sides of the Rops-Fops structure and on the engine
hood. For proper lighting these lights must always be in good
operating condition.
Replace blown bulbs with new ones of the same type.
5.8 SCHEDULED MAINTENANCE
AFTER THE FIRST 8 HOURS OF OPERATION
Check the machine and its units/equipment. Make sure that:
- all the bolts are tightened properly;
- none of the parts in the hydraulic system presents oil lea-
ks;
- moving or rotating parts are lubricated properly;
- only the lubricants recommended by the Manufacturer are
used; genuine spare parts only are used.
Before operating the machine again, make sure that no oil has
leaked to the ground. If this is the case, DO NOT OPERATE
the machine and locate the oil leak.
Possible causes for oil leaks are the following:
- damaged gear units;
- damaged hydraulic oil reservoir;
- damaged components or piping of the hydraulic system.
5
Fig. 67
1 2
2
3
Fig. 66
32
5-16
MAINTENANCE