AccuTrak
VPE-2000
9
Operation
To use the system
, plug the headphones into the jack on the right side of the
instrument ( I ).
Depress the “on/off” button (D.) once to turn the unit on (depress it again to turn
the unit off).
Depending on whether you are in a touchprobe or airborne mode, you will
immediately begin to hear the translated ultrasonic signal from that sensor.
Using the modes...
The AccuTrak VPE-2000 uses a simple method of
select and adjust
. Press the
“Mode” button to select the parameter you wish to change, then use the Up and
Down arrows (G. & H.) to make the adjustment. The AccuTrak VPE-2000 offers
modes in the following order...
Volume
Display
Air (H,L)
Probe (H,L,S)
Oper.
“
” and “
”
(Continuous,
(
“
” and “
”
to active)
Peak Hold,
or Off)
If you reach OPER, it means you are in operational mode, and no settings were
changed. The VPE-2000 will begin the cycle again.
Setting the Sensitivity:
The AccuTrak VPE-2000 always defaults back to sensitivity as the active mode.
This means that after any other adjustment has been made, it will store the
setting in memory, and reset itself so that
“
” and “
”
adjust sensitivity.
Pressing the
“
” and “
”
arrows will adjust the sensitivity while in any sensor
mode. The prefix on the A.N.D. indicates the frequency range of the mode being
changed. For example, the display will read “
H
000” to remind y
ou that you are in
the high frequency band of the active sensor (air or probe).
Setting the Volume:
Pressing the “MODE” button once will put the AccuTrak in the Volume Adjust
Mode. The alphanumeric display will read “Vol” as long as the MOD
E button is
pressed. When released it will show “V000” indicating the current volume
setting. Use the
“
” and “
”
buttons to make the adjustment. You will hear the
volume change as the display changes from “V 000” to “V 255” (the “V” prefix
indicates that volume is the current mode being adjusted).
