background image

 Series eWAVE  

 

 

                   Page 3 

 

 

 

       LT288 April 09, 2020    

IMPORTANT INSTRUCTIONS 

 
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric 
shock, and injury to persons, including the following:  
 
1.  Read all instructions before installing or using this heater. 
2.  This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible 

materials, such as furniture, pillows, bedding, papers, clothes, etc. and curtains at least 3,3 feet (1 m)  from the 
front of the heater. 

3.  Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater 

is left operating and unattended. 

4.  Do not operate any heater after it malfunctions. Disconnect power at service panel and have heater                    

inspected by a reputable electrician before reusing. 

5.  To disconnect heater, turn controls to off, and turn off power to heater circuit at main disconnect panel. 
6.  This heater has hot parts. Do not use it in areas where gasoline, paint, or flammable vapours or liquids are 

used or stored. 

7.  Use this heater only as described in this manual. Any other use not recommended by the manufacturer may 

cause fire, electric shock, or injury to persons. 
 

SAVE THESE INSTRUCTIONS 

 

SAFETY INSTRUCTIONS 

 

 

 
CAUTION – High temperature, risk of fire, keep electrical cords, drapery, 
furnishings, and other combustibles at least 3 feet (0.9 m) from the front of the 
heater and away from the side and rear. 
 

1.  This appliance is intended solely for use as an infrared heater and should not be used for other purposes. The 

manufacturer is not responsible for any damage that could happen for improper use. 

2.  After unpacking make sure that the appliance is complete and shows no signs of visible damage or tampering. 
3.  To reduce the risk of fire, do not store or use gasoline or other flammable vapors and liquids in the vicinity of 

the heater. 

4.  The heater is not intended for use in bathrooms, laundry areas or similar indoor areas. Never locate heater 

where it may fall into water. 

5.  Some fundamental rules which apply to all electrical devices must be observed when using the heater: 

a.  Do not touch the heater with wet hands. 
b.  Do not handle with bare feet. 
c.  Do not let children play with the electrical appliance. 

6.  Do not apply any modification to the product. 
7.  Keep connections dry. 
8.  If the appliance is not used for a long period, turn off the power at the circuit breaker panel. 
 

 

 
Each enclosed area within which the heater is located shall have a temperature 
control device. 
The heater does not feature a device to control ambient temperature. 
All users should be made aware of all aspects of operation and safety and these 
instructions should be retained for reference. 
 

 

Содержание EW30L20Y













Отзывы: