SuperiorFireplaces.US.com
126712-01C
16
INSTALLATION
Continued
Model BK Installation
1. Be certain that all wire terminals are
securely attached to terminals on blower
motor and that the screw retaining the
green ground wire is tight
(see Figure 15).
2. Place blower against lower rear wall of
fi rebox outer wrapper with exhaust port di-
rected upward. Depending on your model,
you may have to carefully route the blower
assembly past controls and brackets and
position blower inside back opening. The
blower will be held in position against the
back wall by magnets incorporated onto
blower housing
(see Figure 15 and 16).
Magnetic Strips
Exhaust
Port
Screw
Green
Ground
Wire
Spade
Terminals
Side View
Firebox Bottom
Air Flow
Direction
Blower
Installed
After
Lower
Panel
Removed
Blower
Location Magnets
CAUTION: Use gloves as
sheet metal parts may be sharp.
4. Place control knob, provided, onto control
shaft
(see Figure 17)
.
5. Check to make sure power cord is com-
pletely clear of blower wheel and there are
no foreign objects in blower wheel. Also,
double check all wire leads and make
sure wire routing is not pinched or in a
precarious position. Correct accordingly.
Figure 15 - Blower Model BK
Figure 16 - Blower Model BK (Side View)
3. Remove metal lock nut from plastic
control shaft by turning lock nut with
pliers counter clockwise. Mount speed
control box by placing plastic control shaft
through hole on lower portion of the left
or right side of secondary face by sliding
control box down through large hole in
fi rebox bottom and up behind fi rebox side
(see Figure 17)
. Secure speed control
to side face with previously removed
lock nut by pushing and turning lock nut
clockwise with pliers until it is tight against
side face of fi replace
(see Figure 17)
.
Control
Shaft
Control
Access
Control
Knob
Lock Nut
Secondary
Face
Figure 17 -Attaching Speed Control
(Model May Vary From Illustration)
