SuperiorFireplaces.us.com
126872-01C
25
OPERATION
Continued
Figure 36 - Setting the Selector Switch, Control
Knob, and Flame Adjustment Knob for Hand-
Held Remote Operation
O
FF
PI
LO
T
LO
IH
REMOTE
OFF
ON
ON
Flame Adjustment
Knob
Control Knob
Selector Switch in REMOTE Position
(Optional Hand-Held Remote Control)
GWMT1 WALL MOUNTED
THERMOSTAT (OPTIONAL)
GWMS2 WALL MOUNTED
SWITCH (OPTIONAL)
OPERATING
BLOWER (OPTIONAL)
Make sure heater switch is on AUTO and set
temperature adjustment on wall thermostat to
desired setting. Thermostat has been electronically
calibrated at the factory and requires no adjustment
or leveling.
Upon installation, thermostat must be allowed to
stabilize at room temperature for a minimum of
30 minutes for proper operation. See installation
instructions on
Page 21
of this manual.
Make sure heater switch is on AUTO. This wall switch
works just like the conventional light switch. Flip
switch up for on and down for off.
NOTE
: Make sure that this switch is not in a position
to be mistaken for a light switch. This may result
in fi replace being inadvertently turned on without
proper precautions being taken. See installation
instructions on
Page 22
of this manual.
This blower has three settings: ON, OFF, and AUTO.
In ON position, blower will operate constantly. In
OFF position, blower will not operate. In AUTO
position, blower will start when thermostat senses
a suffi cient increase in fi rebox temperature.
NOTE
: Your fi replace and thermostat blower will
not turn on and off at the same time. Fireplace
may run for several minutes before blower turns
on. After heater modulates to pilot position, blower
will continue to run. The blower will shut off after
fi rebox temperature decreases.
MANUAL LIGHTING
PROCEDURE
3. To shut off burners only and keep pilot lit, you
can turn control knob clockwise
to
PILOT position, use remote control manual OFF
button, or set selector switch in OFF position.
Shutting Off Burners Only (pilot stays lit)
You may shut off the burners and keep the pilot lit
by doing one of the following:
1. Turn control knob clockwise
to the
PILOT position.
2. Use remote control manual OFF button.
3. Set selector switch in the OFF posi
tion.
1. Follow steps 1 through 6 under
Lighting In-
structions
,
Page 23
.
2. Depress control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through 11,
Lighting Instructions
,
Page 23
.
OPTIONAL HAND-HELD
REMOTE OPERATION
NOTE
: All remote control accessories must be pur-
chased separately (see Accessories,
Page 34
). Fol-
low instructions included with the remote control.
NOTICE: You must light the pilot
before using the hand-held remote
control unit. See
Lighting Instructions
on
Page 23
.
After lighting, let pilot fl ame burn for about one
minute. Turn control knob to ON position. Adjust
fl ame adjustment knob anywhere between HI and
LO. Slide the selector switch to the REMOTE posi-
tion
(see
Figure 36
).
NOTE
: The burner may light if hand-held remote
was on when selector switch was last turned off.
You can now turn the burner on and off with the
hand-held remote control unit.
IMPORTANT
: Do not leave selector switch in RE-
MOTE or ON position when pilot is not lit. This will
drain the battery.
