Operation
900684-01 06/2018
Innovative Hearth Products
DRT3000 Series Direct-Vent Gas Fireplaces
55
NOTE:
Enough glowing ember
material is provided for
several applications. For best
glowing effect, replace the
ember material annually.
Installing the volcanic stone, and glowing embers (traditional models)
WARNING
• Turn OFF all gas and electricity to the appliance before installing the volcanic stone, embers, and logs.
• Do NOT install the logs until the appliance has been completely installed, the gas line connected and
tested for leaks, and the initial burner operation has been confirmed.
• Use of an unapproved log set in the fireplace will void the warranty and will result in incomplete
combustion, sooting, and poor flame quality.
• Logs get very hot and remain hot for up to one hour after the gas supply is turned OFF. Handle the logs
only when cool.
• This appliance is not designed to burn wood. Any attempt to do so could cause irreparable damage to
appliance and prove hazardous.
• If the logs are not installed according to these instructions, improper combustion could occur. This could
result in the excessive production of soot and/or the colorless, odorless, toxic gas carbon monoxide (CO).
NOTE:
Install the firebox liner before placing the stone. Logs can be installed after the volcanic stone.
1.
If necessary, remove the glass door
(
Page 58
)
.
2.
In traditional units, spread the decorative volcanic stone in a pleasing pattern on the firebox floor along the
slope and to the back right and left sides of the burner
(
Figure 47
)
.
NOTE
: It is important to ensure proper
log placement per the manual when installing these units. Verify pilot flame is not obstructed. See Verifying
Appliance Operation on
Page 42.
NOTE:
Do not place stone on the burner.
3.
In traditional units, separate and fluff the glowing embers into pieces approximately the size of a quarter
(
Figure 44
)
.
Figure 43 - Installing the volcanic stone
Figure 44 - Separating the glowing embers
4.
In traditional units, position the separated glowing embers over the small holes on the burner surface (
Figure
49
). Do NOT cover the large burner slots.
Figure 45 - Installing the glowing embers
Air
Holes
Air
Holes
