4
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
WARNING
Young children should be care-
fully supervised when they are
in the same room as the appli-
ance. Toddlers, young children
and others may be susceptible
to accidental contact burns. A
physical barrier is recommended
if there are at risk individuals in
the house. To restrict access to
a fireplace or stove, install an
adjustable safety gate to keep
toddlers, young children and
other at risk individuals out of
the room and away from hot
surfaces.
AVERTISSEMENT
Les jeunes enfants devraient être
surveillés étroitement lorsqu’ils
se trouvent dans la même pièce
que l’appareil. Les tout petits,
les jeunes enfants ou les adultes
peuvent subir des brûlures s’ils
viennent en contact avec la sur-
face chaude. Il est recommandé
d’installer une barrière physique
si des personnes à risques habi-
tent la maison. Pour empêcher
l’accès à un foyer ou à un poêle,
installez une barrière de sécu-
rité; cette mesure empêchera les
tout petits, les jeunes enfants et
toute autre personne à risque
d’avoir accès à la pièce et aux
surfaces chaudes.
GENERAL INFORMATION
INNOVATIVE HEARTH PRODUCTS • POWER VENT DV GAS FIREPLACES (DRC/DRT6340TYN AND DRC/DRT6345TYN) • INSTALLATION INSTRUCTIONS
TABLE OF CONTENTS
Safety and Your Fireplace
...............Page 3
Important Safety Information
.........Page 4
Packaging .........................................Page 4
Introduction ......................................Page 4
General Information ..........................Page 4
Massachusetts Requirements ...........Page 6
Cold Climate Insulation .....................Page 7
Manufactured Home Requirements ..Page 7
Location ............................................Page 7
Vent Termination Clearances ............Page 8
Minimum Clearances to Combustibles Page 10
Pre-Installation Steps ........................Page 11
Typical Installation Sequence ...........Page 11
Detailed Installation Steps .................Page 11
General Vent Information ..................Page 14
Power Vent Components...................Page 14
Vent Section Length Chart ................Page 15
Offset Installation ..............................Page 15
Horizontal Termination System .........Page 18
Installing Power Vent Termination ....Page 18
Typical Installation Sequence ...........Page 20
Attaching Safety-in-Operation
Warnings................................ Page 29
Installation Accessories ....................Page 30
Service and Maintenance Notices .....Page 33
Appliance Operation Notices ............Page 33
Appliance Operation and Care ..........Page 35
Gas Controls / Control Compartments Page 35
Purge Cycle.......................................Page 35
Lighting the Appliance ......................Page 36
Power Vent Operation .......................Page 38
Maintenance ....................................Page 38
Front Glass Enclosure Panel
Removal/Installation ......................Page 39
Log, Volcanic Stone, and Glowing
Ember Placement ..........................Page 41
Burner Adjustments .........................Page 43
Electronic Appliance Inspection........Page 44
Ordering Replacement Parts ............Page 45
Accessory Components ....................Page 46
Lighting Instructions ........................Page 48
Maintenance Schedule ......................Page 50
Troubleshooting ................................Page 51
Replacement Parts List .....................Page 53
Warranty ..........................................Page 57
Please read and understand these instruc-
tions before beginning your installation.
NOTE:
• IF THE BARRIER BECOMES DAMAGED,
THE BARRIER SHALL BE REPLACED WITH
THE MANUFACTURER’S BARRIER FOR THIS
APPLIANCE.
• FOR USE WITH BARRIER(S) PART NO(S).
J7422 (40” MODELS) AND J7423 (45”
MODELS).
PACKAGING
The assembled vented gas fireplace is packaged with:
BOX 1 - Fireplace:
•
Literature Kit (plastic bag shipped
inside firebox),
•
Bags of Glowing Embers, Platinum Embers,
and Volcanic Stone (Traditional Models)
•
Barrier
•
Door Modesty Shield
•
Adaptor with Probe Assembly
•
(1) Remote Control Kit and Receiver Kit
BOX 2 - Power Vent Components:
•
(1) Power Vent Termination
•
(1) Termination Adaptor
•
(1) Horizontal Firestop Assembly
•
(1) Vacuum Hose
•
(1) 11/32" Hose Clamp
•
(1) Strain Relief
•
(1) Bushing
•
(4) Insulated 1/4" Male Terminals
•
(2) #10 Ring Terminals
BOX 3 - Firebox Liner Panels
(Traditional Models)
:
In one of the following panel styles:
• Porcelain Liner Kit - Black
• Ceramic Liner Kit - Red Herringbone
• Ceramic Liner Kit - Buff Herringbone
BOX 4 - Oak Log Set
(Traditional Models)
:
•
(1) Oak Log Set
BOX 5 - Glass Media Kits
(Contemporary Models)
:
•
Reflective Black
•
Reflective Blue
•
Platinum
•
Goldfinger
•
Goldfinger
INTRODUCTION
These
Electronic
appliances are designed to
operate on natural gas and have an electronic
intermittent pilot ignition system. External 120
Volt AC electrical power is required to operate
these units.
These vented gas fireplaces are sealed combus-
tion gas fireplaces designed for residential,
manufactured home, and commercial ap-
plications.
Use Only These Approved Vent Components
These fireplaces are designed, tested and
listed for operation and installation with, the
following (4-1/2" inner and 7-1/2" outer) vent
components only:
•
Secure Vent
®
Direct-vent system compo-
nents manufactured by Innovative Hearth
Products (IHP).
These approved vent system components are
labeled for identification. Do NOT use any other
manufacturer’s vent components with these
appliances.
Children and adults should be alerted to the haz-
ards of high surface temperature and should stay
away to avoid burns or clothing ignition.
Les enfants et les adultes devraient être
infor-més des dangers que posent les tem-
pératures de surface élevées et se tenir à
distance afin d’éviter des brûlures ou que
leurs vêtements ne s’enflamment.
DO NOT ATTEMPT TO ALTER OR MODIFY
THE CONSTRUCTION OF THE APPLIANCE
OR ITS COMPONENTS. ANY MODIFICATION
OR ALTERATION MAY VOID THE WARRANTY,
CERTIFICATION AND LISTINGS OF THIS UNIT.