2. SuperGuard Vehicle Unit – Features
The SuperGuard SG-VT05 is a GPS vehicle tracking device, ideal for fleet
management and commercial data centers.
The SG-VT-05 is easy and quick to install, saving costly installation time
and fees.
Data exchange between device and server is maintained over GPRS and
Internet connection. All commands and configuration details can be sent
either through GPRS or SMS. An SMS only mode is also available.
Up to 3 authorized contact numbers can be configured to inquire vehicle
location through 2-RING phone call or short message command.
Alternately, you will be able to query device location and status over
Internet Website or GPRS enabled cell phones at all times.
You can setup and configure monitoring activities and alerts, using
Control Base software or Tracking Web services via Internet Explorer or
mobile on GPRS enabled cell phones.
Tracking schedules, live tracking and parameters including trip
information such as total travelled distance or trip distance in km can be
configured according to your needs.
You can define and load up to 4 restricted areas (Geo-Fence areas) to the
device and setup maximum speed alert.
The engine immobilizer allows you to disable the vehicle ignition
according to specified trigger times through GPRS or SMS command.
The device comes with one SOS Push Button designed for emergency
alarms to be sent to server and contact numbers. It should be placed at a
hidden place within reach of the driver on the dashboard.
You can configure and activate three power saving modes according to
ignition off time, no movement or no communication time.
6
3. Preparations
In order to install the SuperGuard Vehicle Unit properly, the
following preparations should be carried out:
Prepare one operational GSM SIM card. Make sure that the SIM card can
operate without PIN protection and has GPRS with unrestricted Internet
access enabled (ask your GSM operator for APN and GPRS dial up
requirements). Empty the SMS storage of the SIM card using operational
GSM phone (please refer your GSM phone manual to do this).
1.
Open the battery
cover on the bottom
side of the device and
remove the battery.
2.
Insert the SIM card
into the SIM holder
in the direction as
shown in picture.
3.
Place the battery in the compartment and connect it to the
battery cable.
4.
Replace the battery cover.
7
Battery
Connector
