SuperFlow SF- 902S, Оригинальное руководство пользователя

Страница: 9 / 79

5
2.0 Safety Guidelines
2.1 At Installation
• Do NOT lift the dynamometer by the input
shaft. This may damage the dynamometer and
void its warranty.
!
WARNING
2.2 During Operation
• Extreme care should be taken in the
area of the drive shaft that connects
the engine to the dynamometer.
• All rotating parts must have their
guards secured in place.
• A drive shaft is considered the
fuse in the test setup. In the
event of a failure in the engine or
dynamometer, the shaft may break.
This will save on costly repairs
to an engine or dynamometer.
However, because of this possible
failure, the machine should NEVER
be operated without a shaft guard.
! DANGER
• Engine exhaust contains carbon
monoxide fumes, be sure test cell
is properly ventilated
• If anyone shows signs of carbon
monoxide poisoning, get them
to fresh air. Fumes can cause
headache, dizziness, lack of
consciousness and/or death.
! DANGER
• Take care that the dynamometer is not dropped
or set down sharply. This could cause damage
to the bearing races and brinelling of the
bearings.
• The load cell should be handled with equal
care. Distortion of this cell will hinder its proper
operation.
! CAUTION
WEAR EYE and HEARING
PROTECTION. Proper eye and
hearing protection should be worn
at all times when the equipment is
operating.
! WARNING
AUTOMATIC STARTING HAZARD.
The dynamometer could be started
remotely. Ensure starting has been
disabled prior to servicing.
! WARNING
BURN HAZARD.
During operation water temperature
inside the dynamometer can reach
over 125° F. Do NOT touch discharge
water, piping or the dynamometer
surface during operation. Allow to
cool before servicing.
! WARNING