If you have any questions during the setup process, please call a SuperCloset representative at 1.877.476.9787
1.
Locate your SuperCloner14 (image a). Remove lid, and set aside. Remove
all contents, including the Air Pump, the blue 8” Air Stones, and fourteen
Net Cups.
2.
Unwrap the Air Stones and lay them down inside of the SuperCloner
(image b).
3.
Locate your Air Pump (image c) and place it next to the SuperCloner.
THIS PUMP SHOULD NEVER BE PLACED IN WATER!
4.
Locate and attach the two black tubes (image d) to the metal nodes on the
front of the Air Pump. Run the other end of the black tubing through the
channels located on the rim of the reservoir (image e).
5.
Connect the other end of the black tubing to the Air Stones. Once these
two pieces are connected, ensure the Air Stones remain flat on the floor of
the reservoir.
6.
Turn the black dial on top of your Air Pump clockwise until it stops.
Replace the lid of the SuperCloner and position in the Cloning Chamber
along with the Air Pump into the cloning chamber. Run the Air Pump
Power Cord out of the cabinet through the same Elbow through which you
ran the T5 Light Strip Power Cord. Do not plug in the Air Pump yet.
7.
Insert the 2” net cups.
SuperCloner 14 Assembly
NOTE:
a
b
c
d
e
