WN-Winch-Guide-12000
12
WINCH ASSEMBLY AND MOUNTING:
Winch is designed with a standard bolt pattern for its class.
When installing, ensure that Winch installs to a flat surface so Motor, Winch Drum, and
Gear Housing are properly aligned. Proper alignment allows for even distribution of full
rated loads.
1. Install Fairlead with supplied hardware.
2. Secure Winch with supplied hardware:
- Set Free Spooling Clutch to “DISENGAGED” and pull out a few inches of Synthetic
Rope.
- Feed Synthetic Rope through opening in Fairlead.
3. Make electrical and component connections per See SuperATV instructions.
4. Assemble Clevis Hook to Synthetic Rope.
- Remove Pin from Clevis Hook and connect Clevis Hook to Synthetic Rope.
- Reinstall Pin to Clevis Hook.
5. Install Stopper to Synthetic Rope with supplied hardware.
6. Install Hand Strap to Clevis Hook.
7. Check Winch Drum for proper rotation:
- Set Free Spooling Clutch to “DISENGAGED” and pull out some Synthetic Rope.
- Set Free Spooling Clutch to “HIGH SPEED” and press “OUT” button on remote. If
properly installed, Winch Drum should be turning and
releasing
Synthetic Rope. If
Winch Drum is turning and
collecting
more Synthetic Rope, check and reverse leads
on Motor. Repeat steps and check rotation.
- Remove all jewelry and wear eye protection when making battery
connections. Batteries contain flammable and explosive gases.
Avoid leaning over battery.
CAUTION
Clevis Hook
Pin
Stopper half
Synthetic Rope
Stopper half
M6 x 35mm
M6 Washer
M6 Nut
(4) each
Hand Strap