Superabrasive LAVINA V20E, Руководство пользователя

Страница: 21 / 43

Superabrasive Owner’s manual original language – Lavina
®
V20E 01/2020
21
1. Place the LONGOPAC® bag refill into the support ring. Ensure that the 2 ends of the refill are
directed in an upwards position. Pull the inner end of bag refill down over the inside surface
of the bag support ring by making sure that the hook of the holder sticks out from the bag
(Fig 7.6.1 and 7.6.2).
2. After you install the new bag, you need to attach the holder back to the filter chamber by
following the steps form fig. 7.6, performing it backwards.
3. After you attach it and the zip tie has been securely installed, pull the bag down until the end
reaches the lower, bag-support plate (fig. 7.5.2). The vacuum cleaner is now ready for
operation.
8. MAINTENANCE AND INSPECTION
IMPORTANT: All of the following procedures must be performed with the vacuum cleaner turned off
and the power cable disconnected from the power source. Before performing any work or
maintenance on the vacuum cleaner, be sure to wear the proper protective equipment (clothing, eye
protection, and/or gloves). In order to ensure safe and efficient operation of the vacuum cleaner, the
following procedures should be performed periodically (depending on the frequency of operation):
• Remove and inspect the filters for any signs of excessive wear or damage. Replace as necessary.
• Inspect all electrical components (switches, plugs, cables, etc.) for damage or exposed wiring.
Replace as necessary.
• Ensure that all screws, bolts, and nuts are properly tightened.
• Check the waste container level. Clean and empty the container when the debris reaches a
maximum of 75% of its full capacity.
• Check the flexible vacuum hose and accessories for significant wear or damage. If holes are
present, the vacuum cleaner’s efficiency will be reduced, and debris will leak into the work
environment.