Superabrasive
Owner’s manual original language – Lavina
®
LP36GE
1/2022
39
11. TROUBLESHOOTING
Index of Problems and Solutions
Engine
When troubles occur, be sure to check the simple causes which at first, may seem too obvious to be considered.
For example, a starting problem could be caused by fuel starvation due to an empty propane cylinder or an
unopened service valve. If you do not check for this, starter burnout could result.
Some Troubles and solutions: Surging idle
To smooth out the engines' idle characteristics, adjustment is provided by an idle screw on the lower right side of
the carburetor as viewed from the mufler position. Rotating the screw clockwise will increase the idle speed and this
should cure the "surging idle". If it does not, call o ur customer service.
Starter barely turns the engine over or the solenoid just clicks:
The battery is likely low in charge. This can be remedied by recharging the battery using a 12 Volt battery c harger
at 4.12 amperes.The battery is located under the frame. The positive post is the one with the RED cable attached
to it. Follow the instructions that came with the battery charger. REMINDER: this will continue to happen unless your
engine is run for sufficient time between starts to recharge the battery.
12. DISPOSAL
If your machine after time is not usable or needs to be replaced, send the machine back to Superabrasive or a
local distributor, where a professional disposal complying with the environment laws and directives is guaranteed.
13. MANUFACTURER’S CONTACTRS
If you need to contact Superabrasive Inc. with technical support questions, below is the contact information.
Address: 9411 Jackson Trail Road, Hoshton GA 30548, USA
Email:
Tel.: 706 658 1122
Fax: 706 658 0357
