Superabrasive Lavina 25LM-X, Руководство пользователя

Страница: 11 / 41

Superabrasive User Manual Original Language Lavina® 25LM-X / Lavina® 25LM-X-HV 1/2016
Work at a constant speed allowing the tools time to work at a speed appropriate for the tools’ grit size. Avoid
vibrations. Do not stop the Lavina
®
25LM-X-HV machine in one spot while the tools are still working because they will
leave marks on the floor surface. When working wet, preliminary chose with the water tap (Fig.4.2) the position for water
feed and periodically start the pump (Fig 4.6-7) to release water onto the floor surface. When working dry, check the floor
surface periodically to ensure that dust is not accumulating on the surface, also check regularly if your vacuum works
properly.
If you need to process on the floor with a slope that requires significant effort to work with machine with manual
control, put the button SLOPE in position ON . In this position the activating the button STOP or Emergency stop will not
disconnect wheels and motorgear connection and it will serve as a break on any movement of the machine on the slope.
In that case the machine is operated by the buttons FORWARD ; BACK and STOP, but without possibility to go to
manual control and at the end of the coarse. To switch to manual operation and control of the machine get the button
SLOPE in position OFF and push the button STOP.
STOPPING THE MACHINE
The stopping of the machine must be done gradually until the motor stops. Do not stop moving the machine before
arresting the motor as the tools could damage the surface. To stop switch the off switch (Fig.4.6-15). Use the Emergency
button (Fig.4.6-14) only in emergency or use it to switch the power totally off.
Remember not to hold the machine in one spot before turning off the motor.
The machine drive is stopped by the button STOP (Fig.4.6-9) or Emergency button (Fig.4.6-14)
ALARM
The Alarm light ((Fig.4.6-15) will light incase inverter goes in alarm mode. The most common failure is motor in
overload. To reset the mode push reset button ((Fig.4.6-15).
11