Super Hot EPP SERIES, Инструкция по установке и обслуживанию

Страница: 3 / 24

EPP SERIES INDIRECT WATER HEATERS – Installation and Service Manual
3
1.0 PRE-INSTALLATION
1.1 RECEIVING
INSPECT SHIPMENT FOR POSSIBLE DAMAGE.
All goods are carefully manufactured, inspected,
checked and packed by experienced workers. The manufacturer's responsibility ceases upon delivery of
goods to the carrier in good condition. Any claims for damage and/or shortage in shipment or non-delivery
must be filed immediately against the carrier by the consignee.
Use care when receiving and unpacking the tank. Dropping the tank may cause damage and prevent safe
and proper operation.
1.2 INSTALLATION CODES AND REQUIREMENTS
All applicable national, provincial/state, and local codes, laws, regulations, and ordinances must be
followed. They expand on and take precedence over any recommendations in this booklet. Authorities
having jurisdiction shall be consulted before installations are made.
If an external electrical source is utilized, the hot water tank, when installed, must be electrically grounded
in accordance with local codes or, in the absence of local codes, with the
National Electrical Code,
ANSI/NFPA 70
(current edition) and/or the
Canadian Electrical Code, CSA C22.1 Part 1
(current edition).
If there is any conflict in the above requirements, the more stringent requirement applies.
The installation and service must also conform to the additional requirements in this manual. If there is
any conflict with a requirement in this manual and a code requirement, the code requirement must be
followed.
1.3 LOCATION
•
This tank should not be placed where freezing might occur and is not to be installed outdoors.
•
This tank is designed for vertical installation. Install the tank on an area that is stable, flat, level
and capable of supporting the weight of the tank when filled with water.
CAUTION: Failure to
support and stabilize the water heater could result in severe personal injury, death or substantial
water damage.
•
Although minimal clearance is required for this tank, ensure that there is sufficient room for the
water heater to access all of the fittings easily. We recommend a
service clearance of 24”
around plumbing connections.
•
CAUTION: The tank should be located in an area where leakage of the indirect water heater or
connections will not result in damage to the area adjacent to the appliance or to lower floors of the
structure. When such locations cannot be avoided, it is recommended that a suitable drain pan,
adequately drained (connected to a drain), be installed under the tank.
•
This tank must be installed such that any electronic components are protected from water
(dripping, spraying, rain, etc.) during appliance operation and service.
•
Avoid heat loss and friction loss by locating the tank as close to the boiler as possible. Further
heat loss should be avoided by insulating the pipe.
•
For the fastest delivery of hot water, locate the water heater in a position central to the points of
use.
• DANGER - Risk of Explosion:
Do not use or store gasoline or other flammable fuels or
chemicals which have flammable vapors near the tank. The vapors may be ignited by the heat or
electronic components of the tank.