Use hobby knife to cut off the covering
over the holes for motor cooling hole
and screws.
Install the motor on the head of
fuselage and secure it in place using
M3x8
screws.
Place 2 pieces of 9g servos on the
servo tray. Secure them in place using
the screws.
7
8
Use hobby knife to cut away the
covering on the preserving cooling
holes on the top of the fuselage.
Insert the pushrods into the out tubes.
The length of the rods must be
20-25mm longer than the out tubes.
Slide the pushrod through the rod
connector. Centered the elevator and
rudde, use 1.5mm hex driver to fix the
rods. Pull the outtube straight and
secure it on F3 using CA.
The recommended center of gravity
location is from 70mm back from the
leading edge of the wing. Measured
at the location next to the fuselage.
Take the canopy and use curved
hobby scissors to trim the canopy
according to the tooling line.
Try to find the pre-serving slot on
the head of fuselage for installing
the canopy. Use hobby knife to
remove the covering out of the
slot. Use scissors to trim the
adhesive Velcro tape for applying
on the fuselage and canopy.
