3
4
Use hobby knife to cut off the balsa
wood on the rear edge on the
horizontal.
Try to fit the horizontal to the fuselage.
Please note that the horizontal must
Using hobby knife, carefully cut the
covering inside the marking lines.
Please do not press hard enough to
cut into the wood as doing so could
weaken the horizontal.
Spread epoxy on the top and bottom
of the horizontal where it comes into
contact with the fuselage. Lay the
horizontal onto a flat work surface and
position the fuselage onto it, making
sure it is centered.
Try to fit the vertical on the fuselage.
When satisfy with the location,
carefully mark with a pen the position
of the vertical on both sides where it
exits the fuselage.
Using hobby knife, carefully cut away
the covering inside the lines. Please
do not cut into the wood.
Apply epoxy to the base of the fin
where it comes in contact with the
fuselage. Insert the fin into the
fuselage.
Try to fit wing joiner into each of the
wing panels. It should insert easily.
If necessary, sand the joiner until it is
achieved. Spread epoxy on both
sides of wing joiner and install the
joiner into the cavity on both wing
panels. Wipe away the excess epoxy.
Use a hobby knife to cut an opening
at the center of the wing. Pass the
extension through the hole. Apply the
transparent tape over the hole.
Mix epoxy to glue ply wing joiners on
both sides of metal wing joiner.
Clamped in place to hole the joiner
together while the epoxy cures.
Pen, make a mark on the rod where
he rod will be 5-6mm longer than the
contacting place with the servo arm.
Cut off the excess rod on the marking
place. Insert the rod into the rod
connector. Secure the rod using M3
hex screw.
be on its center position and the
fuselage must be perpendicular to the
rear edge. When satisfied with the
position, carefully mark the position
with a pen at the junction where the
horizontal meets the fuselage.
Connect the Z end on the control horn.
Center the aileron. Using a felt tipped
Use 2mm driller to drill a hole on the
aileron. Secure a control horn on this
hole.
Use hobby knife to remove the
covering out of the wing bolt holes.
Insert the wing bolt through the
washer and secure into the wing
bolt hole.
Insert a piece of 5mm silicone tube
to the thread end of the wing bolt
for avoiding missing.
