6th
1)
Start T-config.exe by window→
LAN Configuration→Connection Type→Static IP(Input IP Address, Subnet Mask, Default
Gateway)→OK
2. Set Serial Port Configuration
Note: The following configuration is factory settings, you can modify according to your own needs.
Factory Settings
Port status:
Data
Data Baud Rate:
115200
Data Format:
8N1
Data Mode:
Transparent
character timeout:
24
Maximum Packet Size:
256 Bytes
No-Connection Data:
Enable
DBUS TCP Status:
Disable
IP Protocol Configure:
UDP Point-to-Point
UDP Point-to-Point settings
Remote IP Address
Input TX with RX IP Address
Input RX with TX IP Address
Remote Port
Default: 20001
