16
ТЕХНИЧЕСКИ ПАСПОРТ. ИНСТРУКЦИЯ за МОНТАЖ и ЕКСПЛОАТАЦИЯ
ТЕХНИЧЕСКИ ПАСПОРТ. ИНСТРУКЦИЯ за МОНТАЖ и ЕКСПЛОАТАЦИЯ
INSTALLATION and OPERATION MANUAL
INSTALLATION and OPERATION MANUAL
7.3. Operating modes of the controller..
7.3.1. Short presentation
P.0 - Off Mode
p.1 - Normal Mode
P.3 - „Electric heater“ mode
P.5 - Automatic mode
P.6 - Photovoltaics - PV mode
P.7 - OFF PEAK Mode
Indicator status
Operating
mode
Description
does not lit
does not lit
Р.0
The thermodynamic water heater is switched off. The display only shows
the temperature of the water in it.
lit
does not lit
Р.1
In this mode, the unit switches on and heats the water to the set
temperature. In case of low inlet air temperature, the controller
automatically shuts off the compressor.
does not lit
flashes
Р.3
In this mode, the water is only heated by the electric heater to the set
temperature. The temperature in the room does not matter.
lit
flashes
Р.5
The appliance is in automatic mode and the water is heated by the heat
pump unit to the set temperature. In case the inlet air temperature is
too low or lower than the set minimum temperature (L1), the appliance
automatically switches to heater mode with electric heater.
flashes
lit
Р.6
The appliance is in automatic mode and the water is heated by the heat
pump unit to the set temperature. In case the inlet air temperature is
too low or lower than the set minimum temperature (L1), the appliance
automatically switches to heater mode with electric heater. In case of PV
signal, the desired value is increased by L6.
flashes
flashes
On alert ON
lit
flashes
Р.7
The device heats the water only when there is an "OFF PEAK" signal. The
logic of operation is the same as in P6 mode.
When the "OFF PEAK" signal is dropped, the water does not heat up. The
maximum temperature setting applies only to this menu and is different
from the settings in - R1, P3, P5 and P6 modes.
By pressing the button for the first time you check the currently selected mode of operation (the same can
be done by checking the status of the light indicators). Pressing the button within 8 seconds switches
between different modes.
- By choosing the mode, you specify the heat source that will overheat the water.
Р
Р
