20
INSTALLATION and OPERATION MANUAL
INSTALLATION and OPERATION MANUAL
INSTALLATION and OPERATION MANUAL
INSTALLATION and OPERATION MANUAL
Explanation of the display indication:
Illuminance level measured by the
photosensor.
Chimney fan speed.
Displays information about the
next action of the timers. If the
timers are not activated or the
burner is on, there will be no information
under the icon. If at least one timer is
active and the burner is on, below the
icon will be the next timer action and
the time or day of the week when it will
occur.
Temperature measured by the
DHW thermosensor.
Calculated burner power at the
moment. In order for this power
to be reliable, you must enter a
calibration constant for the auger from
"Service Settings" -> "Basic Settings" ->
"Auger Fuel Capacity".
Temperature measured by the
flue gas thermosensor.
9.3. Controller operation:
The burner operated by NPBC-V4C-1 can
operate in both continuous mode and
timer mode. When in timer mode, the
burner operates only at user-specified
intervals of the day and days of the
week. During operation, it goes through
several phases:
cleaning, ignition,
fire stabilization, combustion with
modulation of power
depending on
the current and set temperature of the
boiler, intermediate cleaning performed
in the combustion process, extinguishing
and cleaning after combustion. In what
phase is the process of operation of the
burner at the moment, is displayed with
text in green on the bottom row of the
main screen.
Each burner ignition starts with a
cleaning cycle
. The purpose is to remove
all remnants of previous combustion.
First for a specific time set in the
"Service
settings"
menu ->
"Service settings"
combustion "->"Fuel X"->"Cleaning"
column
"Vent"
row
"Start",
only the
main fan works, then the additional fan
for cleaning is turned on, if any and is not
turned off from the time settings set in
the
"FC"
column.
Internet
connecti on
DHW
pump
included
Heati ng
pump
included
Fan
for
cleaing-outlet
included /FC/
Room
thermostat
acti vated
